CyClone Elliptical Trainer Owner's Manual download pdf (Page 29)

E20 / E25 ELLIPTICAL27

GENERAL MAINTENANCE

1. Wipe down all areas in the sweat path with a damp cloth after each workout.

2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of

two reasons:

I. The hardware was not suciently tightened during assembly. All bolts that were

installed during assembly need to be tightened as much as possible. It may be

necessary to use a larger wrench than the one provided if you cannot tighten the bolts

suciently. I cannot stress this point enough; 90% of calls to the service department for

noise issues can be traced to loose hardware or the rear rails being dirty.

II. Dirt build-up on the rear rails and polyurethane wheels are also a source of noise.Noise

from build-up on the rails can cause a thumping sound that you would swear is coming

from inside the main body of the machine because noise travels, and is amplied in the

tubing of the frame. Clean the rails and wheels with a lint free cloth and rubbing

alcohol. Stubborn build-up can be removed with your thumbnail or a non-metallic

scraper, like the back edge of a plastic knife. After cleaning, apply a small amount of

lubricant on the rails with your ngers or a lint free cloth. You only need a thin coat of

lubrication, wipe o any excess.

3. If squeaks or other noises persist, check that the unit is properly leveled before calling the

service department.

MAINTENANCE MENU IN CONSOLE SOFTWARE

The console has built in maintenance/diagnostic software. The software will allow you to

change the console settings from English to Metric and turn o the beeping of the speaker

when a key is pressed for example. To enter the Maintenance Menu (may be called Engineering

Mode, depending on version) press and hold down the Start, Stop and Enter keys keep

holding the keys down for about 5 seconds and the Message Window will display “Engineering

Mode”. Press the Enter button to access the menu below. Press the Level 5/6 keys to

navigate the menu.

A. Key Test - Will allow you to test all the keys to make sure they are functioning

B. Display Test - Automatically tests all LCD’s

C. Functions - Press Enter to access settings, use Level 5/6 keys to scroll

I. ODO Reset - Resets the odometer

II. Units - Choose from English(Imperial) or Metric display readings

III. Display Mode - Turn o to have the console power down automatically after 30 minutes of inactivity

IV. Motor Test - Continually runs the tensioning gear motor

V. Manual - Allows stepping of the gear motor

VI. Pause Mode - Turn on to allow 5 minutes of pause, turn o to have console pause indenitely

VII. Key Tone - Turn on or o the beep sound when a key is pressed

D. Security - Allows you to lock the keypad so no unauthorized use of the machine is allowed. When the child

lock is enabled, the console will not allow the keypad to operate unless you press and hold the Start and

Enter buttons for 3 seconds to unlock the console.

E. Factory Set

F. Exit - Select to exit Maintenance Menu

Incline Calibration: If there is a problem with the incline, try running the calibration. Press the Incline 5

key and the Start key at the same time. Hold them down for 5 seconds and then press Start to begin the

calibration. If the problem persists contact Sole service department.

1 2 ... 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

CyClone Elliptical Trainer Owner's Manual Page 29

Comments to this Manuals